Excels in difficult Back-Lit & High-Contrast situations. Robust swivel / tilt Aluminium alloy Housing.

Suitable for Offices, Warehouses, Homes, Factories, Showrooms, sheltered shaded Outdoor use (under eaves) & Total-Darkness with illumination provided by the inbuilt Infrared Illuminator.

Better than a Dome No washed out low contrast images caused by IR-Lens leak-through - no internal reflections from sides.

an even better Pixim Seawolf Security Camera

 
New Seawolf Digital Pixel System (Pixim) Image Sensor & Chipset this Security Camera solves many of the shortcomings of conventional CCD and CMOS sensors and is ideal for most common and many difficult Security Surveillance applications.

Designed for security surveillance in commercial & domestic applications, this Ball Security Camera can be easily added to an existing Security system (or replace an under performing CCD Camera), simply connect Video Output from Camera to an unused Security DVR Video input.

This Security Camera can also be connected to the Composite Video Input on most TVs and Recording Devices, if required a Microphone can be added and a single small diameter Cable used to carry Video, Audio & Power 20 or more metres.

Uitlising Pixim's 'Seawolf Solution' this Security Camera has an extraordinary 690 HTVL effective resolution, far better than conventional Security Cameras, HTVL Effective Specification.

Better than a Dome separation between LED and Lens glasses eliminates transmission of infrared from LED to Lens that with a one-piece Dome results in a washed out image and a reduction in contrast, also eliminated are internal reflections caused by light entering from behind and sides, these problems cannot be resolved with a conventional one-piece Dome.

Lens: Board Type 3.6 mm Focal Length, there are no optional Lenses for this Camera, security camera lens information.

Image Device: Progressive-Scan Seawolf Solution 768 (H) 548 (V) 420 864 Pixels 758 (H) 540 (V) effective pixels ⅓" format 7 µm x 7 µm pixel size, CMY Colour Array PIXIM® Wide Dynamic Digital Pixel System® Effective resolution 409 320 pixels.

Sensitivity: ~ 0.1 Lux @ F1.2, 50 IRE, 25 fps, CMY (this value is provided for comparative purposes only) Camera produces images in total darkness when Infrared LEDs are 'ON'.

Video System: 2:1 Interlace PAL 50 Hz vertical, 15 625 Hz horizontal. Compatible with TV Systems in Australia, NZ, UK, Japan, etc.

Video Output: Composite Video 75 ohms 1.14 V p-p, BNC socket on ~ 80 cm cable.

Automatic Electronic Shutter (AES): 1/25 to 1/30 720 second.

Dynamic Range (more): 102 dB typically, 120 dB maximum, Dynamic Range is illustrated on this page.

Smear (more): Zero for most practical purposes, copes with highlights better than ordinary CCD cameras, Smear is illustrated on this page.

Spectral Response: ~ 400 to ~ 1000 nm with an Infrared 'CUT' Notch between approximately 720 ~ 830 nm, additional information here.

Signal to Noise ratio (SNR): up to 50 dB, measured with AGC off.

Back Light Compensation (BLC): Automatic, On/Off.

Noise Reduction: 3D, Motion Adaptive.

Flicker Reduction: 'Pixim' Enhanced Flicker Reduction.

White Balance (WB): Automatic Tracking 2200ºK ~ 10000ºK.

Gamma: 0.45.

Infrared Illuminator: 20 Light Emitting Diodes (LED), automatically switch On/Off depending on illumination level, LEDs illuminate up to ~ 80% of the Width-of-Vision at up to ~ 15 m depending on the Infrared reflective characteristics of subject. Objects closer than ~ 2 metres may be overexposed when illuminated by LEDs.

Power Requirements: 12 Volts DC Regulated, ~ 150 milliamps LEDs Off, ~ 250 mA LEDS On, 2.1 x 5.5 mm DC socket, center pin = (+) on ~ 80 cm cable.

Dimensions (mm): ~  94 (Dia) x 70/85.

Mass: ~ 380 grams.

Manufacturer: 18+ years experience. ISO 9001, CE, FCC, RoHS certification. OEM & ODM supplier.

Made in China.